HAMEG Instruments GmbH
Home | Products | Blog | Dealer | Service & Support | Company | Contact    
Warranty & Repair
HAMEG Calibration
Downloads
Knowledge Base
General
Oscilloscopes
Spectrum Analyzer
Power Supplies
Programmable Measuring Instruments Series 8100
Modular System Series HM8000
Accessories
Blog
Dealer's Area
PrintPrint

Knowledge Base

KB > Programmable Measuring Instruments Series 8100 > HM8112-3 
Go to category:
Go to article ID:
Full-text search:
Search for:
Match:
Search in:
Order by:  
at a time
Style:   
 

Regular search

Categories HM8112-3:
folderHM8112-3: Example of a terminal connection with the PC (RS-232)
folderHM8112-3: Display refresh rate
folderHM8112-3S: Built-in scanner card HO112
folderHM8112-3S: LabView driver supports the HO112 scanner card
folderHM8112-3S: Performing measurements simultaneously / sequentially without interrupting the BP channel voltage
folderHM8112-3S: Connecting thermocouple elements (HO112)
folderHM8112-3S: Temperature measurements with scanner card HO112
folderHM8112-3S: Connecting of different sensors (HO112)
articleHM8112-3: Example of a terminal connection with the PC (RS-232)
REMARK: Please clear the buffer (memory) before writing new measured values into the memory!  
articleHM8112-3: Display refresh rate
In the menu of the HM8112-3 you can adjust the time between two measurements from 0.01s to 60s. This means that one measurement value will capture every 0.01s or ...
articleHM8112-3S: Built-in scanner card HO112
With the HO112 scanner card you have 8+1 channels available.   With built-in scanner card HO112 voltage measurements are only possible up to 100V. That means ...
articleHM8112-3S: LabView driver supports the HO112 scanner card
The LabView driver of the HM8112-3 also supports the scanner card HO112 in the HM8112-3S. Please use the VI HM8112-3_Set_MUXChannel.vi.  
articleHM8112-3S: Performing measurements simultaneously / sequentially without interrupting the BP channel voltage
The HO112 is not designd to supply all scanner ports simultaneously. Only the currently active port is supplied with the voltage set on the BP channel. ...
articleHM8112-3S: Connecting thermocouple elements (HO112)
Thermocouple wires are usually extended with copper leads and then connected to the input jacks. It should be noted that the temperature on the equalization point ...
articleHM8112-3S: Temperature measurements with scanner card HO112
Because of the bistable relay of the scanner card HO112 (HM8112-3S), which have virtually no thermal stresses, it is very suitable for temperature measurements. ...
articleHM8112-3S: Connecting of different sensors (HO112)
Using the scanner card HO112 you can connect different sensors (thermocouples, voltages, PT-100). Function and range have to be change for each channel accordingly.
articleback to  Programmable Measuring Instruments Series 8100
 
 
HAMEG summer promotion: Great offers until October 2013 +++ Spectrum Analyzers HMS1000, HMS1010 and HMS1000E now with extended frequency range of 1.6GHz… [more…] +++ Embedded World: HAMEG introduces new HMO3000 series of oscilloscopes with up to 500MHz bandwidth. +++ 
© 2013 HAMEG Instruments GmbH | Imprint | Terms & Conditions