HAMEG: HM8112-3


Warranty & Repair

HAMEG Calibration

Downloads

Knowledge Base
	General
	Oscilloscopes
	Spectrum Analyzer
	Power Supplies
	Programmable Measuring Instruments Series 8100
	Modular System Series HM8000
	Accessories

Blog

Dealer's Area

Knowledge Base

Programmable Measuring Instruments Series 8100

HM8112-3

Go to category:

Go to article ID:

Full-text search:


Categories HM8112-3:

	HM8112-3: Example of a terminal connection with the PC (RS-232)

	HM8112-3: Display refresh rate

	HM8112-3S: Built-in scanner card HO112

	HM8112-3S: LabView driver supports the HO112 scanner card

	HM8112-3S: Performing measurements simultaneously / sequentially without interrupting the BP channel voltage

	HM8112-3S: Connecting thermocouple elements (HO112)

	HM8112-3S: Temperature measurements with scanner card HO112

	HM8112-3S: Connecting of different sensors (HO112)

	HM8112-3: Example of a terminal connection with the PC (RS-232) REMARK: Please clear the buffer (memory) before writing new measured values into the memory!

	HM8112-3: Display refresh rate In the menu of the HM8112-3 you can adjust the time between two measurements from 0.01s to 60s. This means that one measurement value will capture every 0.01s or ...

	HM8112-3S: Built-in scanner card HO112 With the HO112 scanner card you have 8+1 channels available. With built-in scanner card HO112 voltage measurements are only possible up to 100V. That means ...

	HM8112-3S: LabView driver supports the HO112 scanner card The LabView driver of the HM8112-3 also supports the scanner card HO112 in the HM8112-3S. Please use the VI HM8112-3_Set_MUXChannel.vi.

	HM8112-3S: Performing measurements simultaneously / sequentially without interrupting the BP channel voltage The HO112 is not designd to supply all scanner ports simultaneously. Only the currently active port is supplied with the voltage set on the BP channel. ...

	HM8112-3S: Connecting thermocouple elements (HO112) Thermocouple wires are usually extended with copper leads and then connected to the input jacks. It should be noted that the temperature on the equalization point ...

	HM8112-3S: Temperature measurements with scanner card HO112 Because of the bistable relay of the scanner card HO112 (HM8112-3S), which have virtually no thermal stresses, it is very suitable for temperature measurements. ...

	HM8112-3S: Connecting of different sensors (HO112) Using the scanner card HO112 you can connect different sensors (thermocouples, voltages, PT-100). Function and range have to be change for each channel accordingly.


	back to Programmable Measuring Instruments Series 8100

HAMEG summer promotion: Great offers until October 2013 +++ Spectrum Analyzers HMS1000, HMS1010 and HMS1000E now with extended frequency range of 1.6GHz… [more…] +++ Embedded World: HAMEG introduces new HMO3000 series of oscilloscopes with up to 500MHz bandwidth. +++